Микрофон Neumann U 67 Set

Sound-wise, this reissue is identical to the U 67 produced from 1960 to 1971; It uses the same capsule and electronic design. Key parts such as the BV 12 output transformer are carefully reproduced according to the original documentation. EF86 tubing has been carefully selected for optimum performance and lowest noise levels in a dedicated measuring center. The power supply has been redesigned to meet today's stringent safety requirements and to accommodate the slightly higher filament current of the new premium tubes. The new NU 67 V power supply is fully compatible with the old U 67 microphones.

Quality Engineering

The U 67 was the first microphone to feature the famous K 67 capsule, which has since become associated with the Neumann sound and continues to be used in its successor, the U 87 A. Equally important is the U 67's masterful tube circuitry, showing the clever pre-emphasis/attenuation circuitry to minimize pipe hiss. The U 67 was also the first microphone to use modern recording techniques such as mixing. Its switchable low pass filter compensates for the proximity effect that occurs at short recording distances. Using a cushion of -10dB, the U 67 can handle high SPLs up to 124dB without distortion (and much more if you don't mind a little "plugging").

Ready for the studio

The U67 comes with a matching shock, power supply and proprietary 7-pin XLR cable. The microphone and its accessories fit snugly into the supplied aluminum case.

Specifications NeumannU67 Set:

Microphone Type: Condenser

Polar Pattern: Cardioid, Omni, Pattern-8

Frequency response: 20Hz-20KHz

Max SPL: 105 dB (cardioid), 110 dB (omni), 111 dB (Fig. 8)

Output impedance: 50 ohm

Signal to noise ratio: 83 dB (cardioid), 78 dB (omni), 77 dB (Fig. 8)

Noise floor: 11dB (cardioid), 16dB (omni), 17dB (Figure 8)

Low pass filter: yes

Pads: -10dB

Color: pearl gray

Connector: XLR

Weight: 1.08 kg.

Included accessories: shock absorber, wooden box